The salt spray (or salt fog) test is a standardized and popular corrosion test method, used to ASTM B was the first internationally recognized salt spray standard, originally published in Other important relevant standards are. Designation: B – 07a Standard Practice for Operating Salt Spray (Fog) Apparatus1 This standard is issued under the?xed designation B. ASTM B Testing, also known as a Standard Practice for Operating Salt ASTM B Testing requires controls over many operational parameters such as: .
|Published (Last):||6 February 2007|
|PDF File Size:||5.77 Mb|
|ePub File Size:||11.88 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM B – 07a Standard Practice for Operating Salt Spray (Fog) Apparatus
ASTM G85 is an example of a test standard which contains several modified salt spray tests which are variations to the basic salt spray test. This may be done monthly or more frequently to ensure consistent operation over time.
Halides Bromide, Fluoride, and Iodide other than Chloride shall constitute less than 0. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.
Suitable apparatus which may be used is described in Appendix X1. This may be accomplished by placing the apparatus in a b117-007a room, but may also be achieved by surrounding the basic chamber of a jacket containing water or air at a controlled temperature.
Test solution tank L.
Retrieved from ” https: However, these testing standards neither atm information of testing periods for the coatings to be evaluated, nor the appearance of corrosion products in form of salts. The pH of the collected solution shall be 6. Test specimens are placed in an enclosed chamber, and exposed to b1117-07a changing climate that comprises the following 2 part repeating cycle. Options for corrosion chambers. Originally approved in A common method of introducing the air is through an air dispersion device X1.
Vent piping should be of sufficient size so that a ast of back pressure exists and should be installed so that no solution is trapped. It is preferable to saturate the air at temperatures well above the chamber temperature as insurance of a wet fog as listed in Table 2. ISO gives the guidelines for proper measurement of corrosion resistance for hot-dip galvanized specimens. How can I check whether my salt spray test chamber operates properly? NOTE 10—A solution having a speci?
Salt spray test
Before the solution is atomized it shall be free of suspended solids Note 4. The fallout rate should be measured for 16 hours and it must range from 1.
This is followed by 2. The first prerequisite for your test chamber to operate properly is that it is regularly serviced and well maintained. Test specimens are placed in an enclosed chamber, and exposed to a changing climate that comprises the following 3 part repeating cycle.
If the salt used is of lower purity, then test for halides. Different coatings have different behavior in salt spray test and consequently, test duration will differ from one type of coating to another. Test solution tank L complete with tankfilter,hose and fitting. However, in order to obtain reliable results additional requirements must be met. For this purpose Test Method B and Practice G 85 b117-007a available, which are also considered by some to be superior for comparison of chemically treated aluminum chromated, phosphated, or anodizedalthough?
When astmm pH of the salt solution is adjusted to 6.
Salt spray test – Wikipedia
Synthetic seawater solutions are also commonly specified by some companies and standards. Most commonly, the time asgm for oxides to appear on the samples under test is compared to expectations, to determine whether the test is passed or failed. In the automotive industry requirements are specified under material specifications. Heating Blocks for Evaporators. The most appropriate test cycle and spray solutions are to be agreed between parties.
The exposed end of the vent pipe should be shielded from extreme air currents that may cause? Place the panels in the proximity of the condensate collectors.
This does not apply to running tap water. The fog shall be such that for each 80 cm2 Salt Spray Test Chambers.